# $Id: CONFIG,v 1.9 2003/03/31 23:55:11 mpeppler Exp $ # Configuration file for DBD::Sybase. # # The Makefile.PL file attempts to set reasonable defaults for the # variables in this file. # # Where is the Sybase directory on your system (include files & # libraries are expected to be found at SYBASE/include & SYBASE/lib # If not set, uses the SYBASE environment variable. SYBASE=$ENV{SYBASE}||'/opt/sybase' # Additional libraries. # Some systems require -lnsl or -lBSD. # Solaris 2.x needs -ltli # SGI IRIX needs -linsck (and may need need -ltli) # DEC OSF/1 needs -ldnet_stub and may need -lsdna and -linsck or -ltli # SunOS 4.x needs -linsck # HP-UX 10.x needs -linsck # AIX 3.2.5 needs -linsck # Linux needs -linsck # See the Sybase OpenClient Supplement for your OS/Hardware # combination. # If not set, will attempt to determine which libraries are needed by scanning the # $SYBASE/lib directory. EXTRA_LIBS= # DBI_INCLUDE # DBD::Sybase needs access to some C include files that are provided # by the DBI module. These are normally found in $Config{sitearchexp}/auto/DBI # but if they are in some other place on your system then you can specify # that directory here: # DBI_INCLUDE=/usr/local/lib/perl5/site_perl/sun4-solaris/ # BUILD_TYPE # Set this to 64 if you are building in 64 bit mode on a platform # that supports the 64bit OpenClient libraries (libct64.a, etc). # BUILD_TYPE=64 # LINKTYPE # If you wish to link DBD::Sybase statically # into perl uncomment the line below and run the make normally. Then, # when you run 'make test' a new perl binary will be built. #LINKTYPE=static