# This is the main configuration file for the Node Assassin fence device. # # This can support one or more fence devices. # # Node Assassin - Fence Agent # Digimer; digimer@alteeve.com # Nov. 27, 2010 # Version: 1.1.6 # # This software is released under the GPL v2. See the LICENSE file for a copy # of the GPL v2. ############################################################################### # System: # # - Here you setup general values for the fence agent and any/all nodes. # ############################################################################### # This must be set to the number of Node Assassin devices you are using. It # must be a positive integer. #system::na_num = 1 system::na_num = 1 # Version of the fence_na fence agent. system::agent_version = 1.1.6 # This is the log file. If unset, no logging will occur. If using '/var/log/', # be sure that this agent is able to create or edit the file. The default is to # write to '/tmp' to prevent accidental failure of the agent due to # misconfiguration. #system::log = /var/log/cluster/fence_na.log system::log = /var/log/cluster/fence_na.log # If set to '1', messages to STDOUT will be surpressed except in the event of # errors. This can be overridden at the command line with the '-q' switch. system::quiet = 0 # Set this to '1' to enable extra debug information. Ignored if 'system::quiet' # is set. system::debug = 0 # This is the authentication information... It is currently a simple plain text # compare, but this will change prior to first release. system::username = admin system::password = secret ############################################################################### # Devices: # # - Here you setup each fence device. There must be a corresponding # # 'node::X::var' for each node where 'X' is between 1 and 'system::na_num'. # ############################################################################### ### Define values for Node 1. # The node assassin name. This must match exactly with the name programmed into # the given node. na::1::na_name = fence_na01 # This is the IP address and port where I will connect to this node at. # NOTE: THIS MUST MATCH THE VALUE USED IN '/etc/cluster/cluster.conf'! If you # used a resolvable name there, use the same name here. Vice versa for IP # addresses. If this doesn't match the 'ipaddr' argument sent by the 'fenced' # daemon the fence will not work properly! na::1::ipaddr = fence_na01.domain.com na::1::tcp_port = 238 # This is the number of nodes supported by this Node Assassin # (1 node = 2 ports; odd # = reset, even # = power) na::1::max_nodes = 4 # These values are set when the node assassin program switch is run. # NOT YET IMPLEMENTED. na::1::mac = 02:00:00:FF:F0:AA na::1::netmask = 255.255.255.0 na::1::gateway = 192.168.1.1 # These are aliases for each Node Assassin port. They should match the name or # URI of the node connected to the given port. This is optional but will make # the fenced 'list' argument more accurate and sane. If a port is listed here, # then the 'list' action will return '<node_id>,<value>'. If a port is not # defined, 'list' will return '<node_id>,<node::X::name-node_id>'. If a port is # set to 'unused', it will be skipped when replying to a 'list'. na::1::alias::1 = node01.domain.com na::1::alias::2 = node02.domain.com na::1::alias::3 = unused na::1::alias::4 = unused
