# This advanced configuration file allows you to tweak # some R2 protocol definitions. # If you happen to need to tweak definitions of this # file to make openr2 work in your country, please let me # know in order to implement them directly on the library # www.libopenr2.org # No spaces are allowed in parameter definition # ie: parameter = value will not be properly read # use parameter=value instead # Lines starting with '#' or spaces will be IGNORED # This DEFAULT configuration # has the definitions of the ITU R2 variant as used by OpenR2 # and some other sample values (not ITU values) # (may be outdated so don't fully trust this, code is the ultimate reference) ## TONE OVERRIDES ## # The *ONLY* valid tone values are 1234567890BCDEF or X # case sensitive (not accepted b c d e f x) # NOTE that 'A' nor '10' are valid values, use 0 instead # X means invalid tone (when you dont want to support a tone) # Group A tones mf_ga_tones.request_next_dnis_digit=1 mf_ga_tones.request_dnis_minus_1=2 mf_ga_tones.request_dnis_minus_2=7 mf_ga_tones.request_dnis_minus_3=8 mf_ga_tones.request_all_dnis_again=X mf_ga_tones.request_next_ani_digit=5 mf_ga_tones.request_category=5 mf_ga_tones.request_category_and_change_to_gc=X mf_ga_tones.request_change_to_g2=3 mf_ga_tones.address_complete_charge_setup=6 mf_ga_tones.network_congestion=4 # Group B tones mf_gb_tones.accept_call_with_charge=6 mf_gb_tones.accept_call_no_charge=7 mf_gb_tones.busy_number=3 mf_gb_tones.network_congestion=4 mf_gb_tones.unallocated_number=5 mf_gb_tones.line_out_of_order=8 mf_gb_tones.special_info_tone=2 mf_gb_tones.reject_collect_call=X mf_gb_tones.number_changed=X # Group C tones (just Mexico use Group C signals) mf_gc_tones.request_next_ani_digit=X mf_gc_tones.request_change_to_g2=X mf_gc_tones.request_next_dnis_digit_and_change_to_ga=X # Group I tones mf_g1_tones.no_more_dnis_available=F mf_g1_tones.no_more_ani_available=F mf_g1_tones.caller_ani_is_restricted=X # Group II tones mf_g2_tones.national_subscriber=1 mf_g2_tones.national_priority_subscriber=2 mf_g2_tones.international_subscriber=7 mf_g2_tones.international_priority_subscriber=9 mf_g2_tones.collect_call=X # Timers in milliseconds # Use -1 to leave default, or just comment it out for that matter timers.mf_back_cycle=1500 timers.mf_back_resume_cycle=150 timers.mf_fwd_safety=10000 timers.r2_seize=8000 timers.r2_answer=80000 timers.r2_metering_pulse=0 timers.r2_double_answer=400 timers.r2_answer_delay=150 timers.cas_persistence_check=500 timers.dtmf_start_dial=100 ## misc settings ## # time that a MF tone should persist before handling it mf_threshold=0
