To install 1) unpack the archive (tar xzf taper-7.0pre-1.tar.gz) 2) edit Makefile There are several options - read the taper.txt for details about which ones to set etc.. Also, change the directories if you want to install in different directories 3) do a 'make clean; make all' (you can ignore warnings when compiling the compress code) make sure you have the forms library of ncurses installed - see the FAQ for further details 4) do a 'make install' to install files in correct locations make sure that /sbin is on your path (or wherever you install taper) 5) to start taper: taper -T [tape_type] [tape_type] = zftape or ftape or scsi or file or removable People using libc-5.3.12 should note that taper (and quite a few other applications) does not like this release and can seg fault in odd places. The solution is to downgrade to libc-5.2.18 or try and use the latest binutils (2.6.0.14) [this may not work]. 6) to make a statically linked version of taper for use in emergency rescue disks, do 'make taper-static' and the resulting file (taper-static) will not require any libraries to be on-line when running. READ THIS!!!!!!!!!!!! --------------------- I know that very few of you will read the full documentation. That is fine as long as taper works for you. Howver, if you run into problems, please read the documentation before firing off your e-mail editor and asking me. A lot of your questions will be answered in the relatively short FAQ, saving you from having to read the entire documentation. I do not mind receiving mail - in fact, a lot of suggestions, bug fixes, improvements came from people mailing me - but only after you have read the docs and not found the solution in them. If you find that some aspect of the documentation is not clear, by all means, e-mail me a tell me and I'll try and clarify it in a later version. If you have a bug to report, please read the BUGS file for the sort of information I need. Yusuf 19MAY02 $Id: INSTALL.raw,v 1.2 1997/07/06 04:06:24 yusuf Exp $