## ## This file is used to configure emu10k1's emu-script ## CARD_IS_5_1=no USE_DIGITAL_OUTPUT=no ENABLE_TONE_CONTROL=yes # Note, it's safe to say yes to the next option even if you're not going # to use it. When this option is enabled, the driver can autodetects AC3 # data and behaves normally with normal audio. # (Saying yes causes some of the soundcard's resourses to be used up) AC3PASSTHROUGH=no # Change this to yes to enable the Livedrive midi port and IR remote # control. ENABLE_LIVEDRIVE_IR=no # Most Lives have their analog front signals inverted. If you have # problems with your setup (low bass), try changing this to 'yes'. (This # option has no effect with digital setups) INVERT_REAR=no #Multichannel playback (for 4 - 6 channel setups) MULTICHANNEL=yes # On 5.1 cards in multichannel mode, should the multichannel data be fed # to the sub as well? You probably don't want this if you have a # speaker set like the DTT2200 which already feeds all channels to the # sub in hardware. ROUTE_ALL_TO_SUB=no # By default, the front analog channels have a +12dB boost applied to # them by the AC'97 mixer. If you encounter clipping, or find that the # volume of the front speakers is too high in a multichannel setup, try # changing this to 'no'. ANALOG_FRONT_BOOST=no # Surround ################## # Some wavs, or mp3 are surround sound encoded the next two # options can be used to decode these in hardware. # (select on or the other, not both) # passive matrix surround decoder SURROUND=no # Active matrix surround decoder PROLOGIC=no # Extra Inputs ################# ## This connector is mounted on the card itself ENABLE_CD_Spdif=yes # Volume control is 'Digital1' in aumix/gmix/kmix # The next four inputs are found on Livedrives, some of these may also # be inputs on the older add-on daughter cards. ENABLE_OPTICAL_SPDIF=no # Volume control is 'Digital2' ENABLE_LINE2_MIC2=no # Volume control is 'Line2' ENABLE_RCA_SPDIF=no # Volume control is 'Digital3' ENABLE_RCA_AUX=no # Volume control is 'line3'
