Sophie

Sophie

distrib > Mandriva > 2008.1 > x86_64 > by-pkgid > bf800c686e5d2014df6842c5e5b952b1 > files > 1

sane-backends-iscan-1.0.19-3mdv2008.1.x86_64.rpm

# epkowa.conf -- sample configuration for the EPKOWA SANE backend
# Copyright (C) 2004  Olaf Meeuwissen
#
# See sane-epkowa(5), sane-scsi(5) and sane-usb(5) for details.

# SCSI scanners can be configured simply by listing the path to the
# device.  For example, if your system claims to have a /dev/scanner
# SCSI device, all you have to do is uncomment the following line:
#
#/dev/scanner
#
# In the interest of maintainability, most installations would have
# /dev/scanner sym-linked to the real SCSI scanner device node.
#
# An alternative way that works for many operating systems and is a
# little bit more generic, is to have the backend probe for your SCSI
# scanner with the following configuration command:
#
scsi EPSON

# On systems with libusb, the following line is sufficient to get the
# backend to recognise your USB scanners.  It presumes, however, that
# the scanner---more precisely, it's USB product ID---is known to the
# backend.
# For all USB scanners that are officially supported by this backend,
# this presumption is true.  A list of such scanners can be found in
# sane-epkowa(5).
#
usb

# For any USB scanner not known to the backend (yet), you may, at your
# own peril(!!), force the backend to recognise and use it via libusb.
# You can do so by the following configuration command:
# 
#   usb <USB vendor ID> <USB product ID>
#
# SEIKO EPSON's USB vendor ID is '0x04b8' (without quotes).  In order
# to find the USB product ID, use lsusb(1) or, on Linux systems, peek
# at the information in /proc/bus/usb/devices.
# A sample configuration for the Perfection 1650 (GT-8200), which has
# a product ID of 0x0110, would look as follows:
#
#usb 0x04b8 0x0110

# When not accessing your USB scanner via libusb, you may need to use
# one of the configuration commands below or commands that are almost
# the same.  These commands typically access the scanner via a kernel
# scanner module.
#
#usb /dev/usb/scanner0
#usb /dev/usbscanner0
#usb /dev/uscanner0
#
# Linux had a scanner module until version 2.6.2.  As of version 2.6.3
# libusb is your only option.  Linux' scanner module can be loaded via
# the modprobe(8) command like so:
#
#   modprobe scanner vendor=<USB vendor ID> product=<USB product ID>
#
# If the scanner module already knows the vendor and product IDs, you
# do not have to specify them.  If you want to have this done automa-
# tically every time you boot, you can add the above line, except for
# the modprobe command itself, to your /etc/modules file.

# Although not tested with this backend, parallel port scanners should
# be usable.  You can configure them as shown below, but I do not know
# much about the details.  Information is welcome.
#
#pio 0x278
#pio 0x378
#pio 0x3BC