Kernel driver `mic74.o'
=========================

Status: Beta

Supported chips:
  * Micrel MIC74
    Prefix: 'mic74'
    Addresses scanned: I2C 0x20 - 0x27
    Datasheet: Publicly available at the Micrel website
               http://www.micrel.com/

Authors: zebo25
         mds (cleanups and this doc)

Module Parameters
-----------------


Description
-----------
The MIC74 is an 8-bit I/O expander for the I2C bus.
Semiconductors. It is designed to provide a byte I2C interface to up to 8 
separate devices.

This device consists of a quasi-bidirectionnal port. Each of the eight I/Os
can be independently used as an input or output.

The driver does not initialize the ports, they will be at their
power-up defaults, or however the BIOS programmed them.

For more information see the datasheet.


Accessing MIC74 via /proc interface
-------------------------------------

! Be careful !
The chip is plainly impossible to detect ! Stupid chip.
So every chip with adress in the interval [20..27] could be
detected as an MIC74 or a PCF8574. Don't load both drivers.
If you have other chips in this address
range, the workaround is to load this module after the one
for your others chips.

On detection, directories are created for each detected chip:

	/proc/sys/dev/sensors/mic74-<0>-<1>/
	where <0> is the bus the chip was detected on (e. g. i2c-0)
	and <1> the chip address [20..27]: 
	./mic74-i2c-0-27/

Inside these directories, there are seven files each,
one for each of the seven registers in the device.

At this point you really need the datasheet.
It should be self-explanatory which file is for which register.