# Customized settings for lirc daemon # The hardware driver to use, run lircd --driver=? for a list DRIVER="" # Hardware driver module to load HWMOD="" # The device node that communicates with the IR device. # if you are using lirc_serial, set DEVICE to /dev/ttyS[0-9] # where 0-9 is the serial port your IR receiver is plugged # with devfs enabled DEVICE=/dev/lirc/0 #DEVICE=/dev/lirc/serial # without devfs #DEVICE=/dev/lirc # Serial port for the receiver (for serial driver) # COM1 (/dev/ttyS0) #COM_PORT=/dev/ttyS0 #DRIVER_OPTS="irq=4 io=0x3f8" # COM2 (/dev/ttyS1) #COM_PORT=/dev/ttyS1 #DRIVER_OPTS="irq=3 io=0x2f8" # COM3 (/dev/ttyS2) #COM_PORT=/dev/ttyS2 #DRIVER_OPTS="irq=4 io=0x3e8 # COM4 (/dev/ttyS3) #COM_PORT=/dev/ttyS3 #DRIVER_OPTS="irq=3 io=0x2e8"