# # There are lots of options in this file. All you have to have is a set # of nodes listedJ {"node ...} # and one of {serial, udp, or ppp-udp} # # keepalive: how many seconds between heartbeats # keepalive 1 # # deadtime: seconds-to-declare-host-dead # deadtime 3 # hopfudge maximum hop count minus number of nodes in config hopfudge 1 # # serial serialportname ... #serial /dev/ttyS0 # # Only for serial ports. It applies to both PPP/UDP and "raw" ports # # This means run PPP over ports ttyS1 and ttyS2 # Their respective IP addresses are as listed. # Note that I enforce that these are local addresses. Other addresses # are almost certainly a mistake. #ppp-udp /dev/ttyS1 10.0.0.1 /dev/ttyS2 10.0.0.2 # # Baud rate for both serial and ppp-udp ports... # #baud 19200 # # What UDP port to use for udp or ppp-udp communication? # udpport 1001 # # What interfaces to heartbeat over? # udp eth1 # # Watchdog is the watchdog timer. If our own heart doesn't beat for # a minute, then our machine will reboot. # #watchdog /dev/watchdog # # File to wirte debug messages to debugfile /var/log/ha-debug # # # File to write other messages to # logfile /var/log/ha-log # # # Facility to use for syslog()/logger (alternative to log/debugfile) # logfacility local0 # # # Tell what machines are in the cluster # node nodename ... -- must match uname -n #node ken3 #node kathy node test1.mydomain.net node test2.mydomain.net