# ========================================================================= # $Id: vhosts.conf 43 2005-10-31 00:10:10Z s0undt3ch $ # ========================================================================= # Please read the README and FAQ for more info. # # Use this file to set up servers on machines behind your # gateway. Use this format: # allowedhost:virtualhostIP:originalport:destinationport:protocol # where allowedhost is an IP address or subnet, or 0/0 to # allow the whole world access. # # Ports and protocols are semi-optional. If you omit originalport # you must also omit destinationport, and all traffic matching # protocol will be forwarded, and protocol is not optional. If # originalport and destinationport are specified but protocol is # not, both tcp and udp ports will be forwarded. # # Examples: #0/0:192.168.0.10:7777-7788:7777-7788:udp # UT or UT2k3 on 192.168.0.10 #0/0:192.168.0.10:28902:28902:udp # UT or UT2k3 on 192.168.0.10 #0/0:192.168.0.10:8000:8000:tcp # UT or UT2k3 on 192.168.0.10 (web admin) #0/0:192.168.0.10:5120-5300:5121:udp # NWN server #0/0:192.168.0.10:6881-6889:6881-6889:tcp # Bittorrent #0/0:192.168.0.10:1241:1241:tcp # nessus server #0/0:192.168.0.10:28765:28765: # cube #0/0:192.168.0.10:6436:6436:tcp # gnutella #0/0:192.168.0.10:2234-2235:2234-2235: # Operation FlashPoint #0/0:192.168.0.10:2300-2400:2300-2400:tcp # m$fs and OFP #0/0:192.168.0.10:6073:6073:tcp # m$fs and OFP #0/0:192.168.0.10:47624:47624:tcp # m$fs and OFP #0/0:192.168.0.10:49000:49000: # xplane #0/0:192.168.0.10:4000:4000:tcp # To enable file icq file xfer, config #0/0:192.168.0.10:4000-4100:4000-4100:tcp # icq to listen on ports 4000-4100 (default)