# GDM Custom Configuration file. # # This file is the appropriate place for specifying your customizations to the # GDM configuration. If you run gdmsetup, it will automatically edit this # file for you and will cause the daemon and any running GDM GUI programs to # automatically update with the new configuration. Not all configuration # options are supported by gdmsetup, so to modify some values it may be # necessary to modify this file directly by hand. # # This file overrides the default configuration settings. These settings # are stored in the GDM System Defaults configuration file, which is found # at the following location. # # /usr/share/gdm/defaults.conf. # # This file contains comments about the meaning of each configuration option, # so is also a useful reference. Also refer to the documentation links at # the end of this comment for further information. In short, to hand-edit # this file, simply add or modify the key=value combination in the # appropriate section in the template below this comment section. # # For example, if you want to specify a different value for the Enable key # in the "[debug]" section of your GDM System Defaults configuration file, # then add "Enable=true" in the "[debug]" section of this file. If the # key already exists in this file, then simply modify it. # # Older versions of GDM used the "gdm.conf" file for configuration. If your # system has an old gdm.conf file on the system, it will be used instead of # this file - so changes made to this file will not take effect. Consider # migrating your configuration to this file and removing the gdm.conf file. # # If you hand edit a GDM configuration file, you can run the following # command and the GDM daemon will immediately reflect the change. Any # running GDM GUI programs will also be notified to update with the new # configuration. # # gdmflexiserver --command="UPDATE_CONFIG <configuration key>" # # e.g, the "Enable" key in the "[debug]" section would be "debug/Enable". # # You can also run gdm-restart or gdm-safe-restart to cause GDM to restart and # re-read the new configuration settings. You can also restart GDM by sending # a HUP or USR1 signal to the daemon. HUP behaves like gdm-restart and causes # any user session started by GDM to exit immediately while USR1 behaves like # gdm-safe-restart and will wait until all users log out before restarting GDM. # # For full reference documentation see the gnome help browser under # GNOME|System category. You can also find the docs in HTML form on # http://www.gnome.org/projects/gdm/ # # NOTE: Lines that begin with "#" are considered comments. # # Have fun! [daemon] [security] [xdmcp] [gui] [greeter] [chooser] [debug] # Note that to disable servers defined in the GDM System Defaults # configuration file (such as 0=Standard, you must put a line in this file # that says 0=inactive, as described in the Configuration section of the GDM # documentation. # [servers] # Also note, that if you redefine a [server-foo] section, then GDM will # use the definition in this file, not the GDM System Defaults configuration # file. It is currently not possible to disable a [server-foo] section # defined in the GDM System Defaults configuration file. #
