# UML File Version version=1.0 # The following settings are used to set # up the uml diagrams. # # The directory containing the stub files # stub.dir=.\\settings # # Size of the box where a segmented line changes direction # sticky.point.size=3 # # Size of the area where you must be to select the sticky point # halo.size=6 # # The type of icon for the UML diagram. The valid types are: # colored circle - the original for specifying scope # letter - a letter + for public, # for protected, etc # icon.type=colored circle # UML File Version version=1.1 # The following settings are used to set # up the uml diagrams. # # The directory containing the stub files # stub.dir=.\\settings # # Size of the box where a segmented line changes direction # sticky.point.size=3 # # Size of the area where you must be to select the sticky point # halo.size=6 # # The type of icon for the UML diagram. The valid types are: # colored circle - the original for specifying scope # letter - a letter + for public, # for protected, etc # icon.type=colored circle # # A pattern to cause the loading to skip # a particular directory. For instance, # .cvs means that JRefactory will skip loading # any directory that matches *.cvs*. Additional # patterns can be separated by the path separator # character # skip.dir= # The extension to add to the existing file when it is # refactored. The # represents the number of the copy # of the file # backup.ext=.# # UML File Version version=1.2 # # This is used by the command line version # of the program to launch a source code editor # The command line program can get either 1 or # 2 arguments. These are: # $FILE - the path to the file for the editor # $LINE - the line number # If your editor cannot accept the line number # command line, leave out that variable # source.editor=notepad $FILE #source.editor=gnuclientw -F +$LINE $FILE