#
# Default settings for IPPP
# Put common settings here, and special settings in the profile files
#
#### ISDN Config settings

# Config name
I4L_PROFILENAME="IPPP-Default"

### ISDN Device settings

# name of master device
DEVICE="ippp0"

# name of slave device for multilink ppp
# SLAVE=slave0

# Bootmode
ONBOOT="no"

### ISDN PPP settings

# Remote username 
#I4L_USERNAME="linuxlogin"

# Remote systemname
#I4L_SYSNAME="linuxisp"

# Local systemname
#I4L_LOCALNAME="linuxbox"

# PPPoptions
I4L_PPPOPTIONS="noipdefault ipcp-accept-local ipcp-accept-remote -vj -bsdcomp noccp"

# PPPBind
I4L_PPPBIND="yes"

### ISDN phone settings

# my phone number
#I4L_LOCALMSN="33333333"

# remote station phone numbers dialout ("111111 222222 333333")
#I4L_REMOTE_OUT="11111111 22222222"

# remote station phone numbers dialin ("2222222 1111111 333333")
#I4L_REMOTE_IN="1111111 2222222"

### ISDN link settings

# Ondemand dialmode ("off" "manual" "auto")
I4L_DIALMODE="manual"

# dialmode for SLAVE ("off" "manual" "auto") (usually auto, as recommended by i4l FAQ)
I4L_DIALMODE_SLAVE="auto"

# Ondemand idletime before hangup (in seconds)
I4L_IDLETIME=180

# hangup befor next charge info ("on" or "off")
# this only works, if your isdn-provider transmits the charge-info during
# and after the connection
# it does NOT work with the Teles on an EDSS1-Line :-(
I4L_CHARGEHUP=off

# hang-up-timer for incoming calls ("on" or "off")
I4L_IHUP=off

# Set the number of dial atempts for each number
# set to "" for unlimited
I4L_DIALMAX=3

# secure
# "on"  = only defined numbers are allowed to call in
# "off" = all numbers are allowed to call in
I4L_SECURE="on"

# callback ("on", "off", "in" or "out")
# the other host must accept this
I4L_CALLBACK="off"

# callback delay in seconds (default: 5)
I4L_CBDELAY=5

# activ hangup when getting an incoming call (default: "on")
I4L_CBHUP="off"

### ISDN protocol settings

# layer-2 protocol (default: "hdlc")
# With the ICN-driver and the Teles-driver, "x75i" and "hdlc" is available.
# With other drivers, "x75ui", "x75bui" may be possible too
I4L_L2="hdlc"

# layer-3 protocol (only "trans" is allowed)
I4L_L3="trans"

# encapsulation
# possible values: "rawip" (default), "ip", "cisco-h", "ethernet",
# "syncppp", "uihdlc"
# see: /usr/src/linux/Documentation/isdn/README
I4L_ENCAP="syncppp"

### ISDN Network settings

# my ip address
#IPADDR="192.168.100.1"

# remote ip address
#REMOTEADDR="192.168.100.2"

# Remote netmask
#NETMASK="255.255.255.0"

# Remote networkaddress
#NETWORK="192.168.100.0"

# Remote broadcast
#BROADCAST="192.168.100.255"