Technical notes on version 3.8.2Beta14
                        24 June 2001
                        Kern Sibbald

General:
- Fixed stall in Network Information Server
- Fixed possible race condition in pthreads
  Network Information Server.
- Fixed a serious shutdown bug for BackUPS UPSes.
- Tightened security for some scripts (thanks
  Neil).
- More cleanups for --with-pwrfail-dir so it
  is properly configured.

Changes submitted this submission:
- I've been having Internet outages here due to the
  heat, and this created a situation where processes
  accessing the Network Information Server would 
  become stuck. This turned out to be either related
  to the KEEPALIVE option being set or the fact that
  a shutdown() was not done on the connection.
  The problem occurred only after about 1500 accesses.
  Fixed by deleting the KEEPALIVE code and by 
  adding shutdown() before closing the socket.
- In examining the above problem, I realized that
  the pthreads code for STATUS uses a global buffer.
  Since it is a bit difficult to make this buffer local
  without a lot of coding, I serialized the accesses
  with a mutex.
- John McSwain was experiencing a strange problem
  on his system with a BackUPS Office where apcupsd
  would issue the commands to shutoff the UPS power,
  it would then log a failure message, reboot the
  system, and a minute later during the reboot
  the power would be cut.
  This turned out to be very old code, dating back
  to at least 3.6.2 that assumed that a "dumb" UPS
  would instantantly cut the power when requested to
  do so, which was apparently the case. The newer UPSes
  however, typically wait one or two minutes before
  cutting the power. Apcupsd had a 10 second wait,
  after which it assumed the power would not be cut
  and rebooted the machine.
  I've removed this code. apcupsd now logs appropriate
  messages and then exits. 
  Thanks to John for his perseverence in testing this!
- Tightened security on mode bits for the daemon
  start script apcupsd, apccontrol, and 
  ups-monitor (in Debian). Made the same changes in
  a number of other distributions.
- Not all the files in all the distributions correctly
  accepted the ./configure --with-pwrfail-dir correctly.
  Quite a number of small distribution script modifications.
  Also added a few .in files so that they would be corrrectly
  configured.